ELECTRICAL
10.7
To enter the diagnostics mode:
1. Turn the key switch off and wait 10 seconds.
2. Set the park brake and shift the transmission to
neutral.
3. Hold the mode/reverse override button as you
turn the key switch on.
The initial screen displayed looks similar to Ill. 1 and
is referring to the software version currently installed
in your instrument cluster. This information is only
briefly displayed.
Ill. 1
Use the mode/reverse override button to toggle
through the diagnostic screens.
The first screen indicates battery voltage. Refer to Ill.
2.
Ill. 2
Screen three (Ill. 4) is the tachometer for setting idle
speed. This mode is not operational while in motion.
Ill. 4
NOTE: As long as you are in the diagnostic mode, the
wrench icon will remain lit.
To leave the diagnostic mode, either shift the machine
out of neutral or turn the key switch off and on.
NOTE: Any movement of the tires will trigger the
speedometer out of the diagnostic mode.
To Next Page
Loading...
