BODY / STEERING / SUSPENSION
5.6
T--25 Screws
View -- Under Right Fender
Winch Installation Area
6. Remove the front cover piece by lifting up on
sides of the two locking tabs as shown. Pull the
tabs out of the notches and lift up on the cover
piece.
Pull Out to Remove
To install the front cover place top lip of the cover into
the groove in the rack, then press in the bottom of the
cover until the notches snap into place.
Lip
Groove
2. Press Tabs In
1. Place Lip in Groove
7. Remove the front headlights (C) or simply
disconnect the electric connector (D) before
removing the front plastic bumper.
C
D
8. Remove the remaining bolts and screws that
secure the front bumper section to the frame.
To Next Page
Loading...
