TRANSMISSION
8.14
35. To remove the remaining bearing on the snorkel
shaft (U), remove the retaining ring and press the
bearing off.
U
TRANSMISSION ASSEMBLY
1. Install all new seals in the gearcases. Use the
Rear Output Seal Driver (PN 2871698) and Rear
Driveshaft Seal Guide (PN 2871699) to installthe
seals into the gearcases. See illustration 1 to
identify seals for replacement.
LH Gearcase
Cover Seals
Gearcase Seal
Snorkel Seal
ILL 1
2. Reverse the disassembly procedure for the
assembly of the snorkel shaft assembly.
3. Inspect the output gear assembly (A), replace
bearings if needed. Inspect the 91T gear for nics ,
chips, or abnormal worn teeth.
A
4. Install 2 new O--rings onto the snorkel tube. Apply
a white lithium grease onto the O--rings and
threads of the snorkel tube.
5. Install the snorkel shaft assembly into the
gearcase. Install the snorkel shaft assembly in
until the second O--ring is contacting the
gearcase, but is still visible.
To Next Page
Loading...
