TRANSMISSION
8.13
31. Use a 2 3/8” wrench to loosen and remove the
front drive shaft snorkel tube (T).
T
Front Drive Snorkel Assembly
A. O--ring
B. Seal
C. Retaining Ring
D. Retaining Ring
E. Spacer
F. Ball Bearing
G. Snorkel Tube
H. Retaining Ring
I. Ball Bearing
J. Snorkel Shaft
A
B
C
D
F
G
H
I
J
A
E
32. If needed, remove the seal from the front of the
snorkel tube. Remove the snap ring.
33. Remove the second snap ring and spacer from
the snorkel shaft.
NOTE: Shim may or may not be present. Depending
on input shaft tolerance.
34. To remove the snorkel shaft from the snorkel
tube, use a press to press the snorkel shaft out.
To Next Page
Loading...
