11.9
REAR SUSPENSION
INSTALLING HEAVIER SPRINGS ON A
FUSION SUSPENSION
Please reference the following information when installing
heavy torsion springs on 2005 Fusion sleds. The issue that
arises when installing the heavy spring on a Fusion sled is that
the coil stack of the torsion spring is wide enough to interfere
with the suspension arm clamp nut. To work around this issue
you will need to order two (one for each side) of the following
parts. Relocate the two washers that are next to the clamp nut
to the outside of the link arm.
To Next Page
Loading...
Need help?
General
