26
FEATURES AND CONTROLS
Seat Belts
Seat Belt Inspection
Inspect all seat belts for proper operation before each use of
the vehicle.
1. Push the latch plate into the buckle until it clicks. The
latch plate must slide smoothly into the buckle. A click
indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to
make sure it releases freely.
3. Pull each seat belt completely out and inspect the full
length for any damage, including cuts, wear, fraying or
stiffness. If any damage is found, or if the seat belt does
not operate properly, have the seat belt system checked
and/or replaced by an authorized POLARIS dealer.
4. To clean dirt or debris from the seat belts, sponge the
straps with mild soap and water. Do not use bleach, dye or
household detergents.
To Next Page
Loading...
Need help?
General
