To Next Page

To Previous Page

OPERATION

Attachments (Models HD and HDPTO)

Installing And Removing Attachments

The PRO-TACH attachment system is used for fast changing

of buckets and other attachments. See the appropriate

Attachment Owner’s Manual to install other attachments.

Installing:

1. Remove the two

retainers (Item 1) and

pins (Item 2) from the

storage position.

2. Start the engine. See

page 41. Move the

gear selector lever to

LOW.

3. Lower the attachment

arm ant tilt the attach-

ment interface forward.

4. Slowly drive forward

until the front edge of

the attachment inter-

face is completely

under the top lip of the

attachment (Item 3).

5. Tilt the attachment

interface backward

until the attachment is

slightly off the ground.

6. Move the gear selec-

tor lever to PARK and stop the engine. See page 41.

7. Install the two pins

(Item 1) and retainers

(Item 2) (both sides).

8. Connect the auxiliary

hydraulic hoses (if

equipped). See page

46.

9. Connect the PTO

driveline (if equipped).

See page 51.

Polaris BRUTUS Owner's Manual

Other manuals for Polaris BRUTUS