30
FEATURES AND CONTROLS
Instrument Cluster
Information Display Area
Programmable Service Interval
The initial factory service interval setting is 50 hours. Each
time the engine is started, the engine hours are subtracted
from the service interval hours. When the service interval
reaches 0, the LCD wrench icon will flash for approximately
10 seconds each time the engine is started.
To change the hour setting or reset the function, follow these
steps:
1. Toggle the MODE button until the wrench icon is displayed in the information area.
2. Press and hold the MODE button until the information display area begins to flash.
3. Toggle the MODE button to increase the service interval hours in 5 hour increments to a
maximum of 100 hours.
4. To turn off the service interval function, toggle the MODE
button until “OFF” is displayed.
Check Hydraulic
This display indicates that hydraulic oil pressure is too low,
likely caused by a plugged line or by hydraulic oil
temperature being too high. The Oil or Temperature light will
illuminate along with this message.
To Next Page
Loading...
Need help?
General
