111
MAINTENANCE
Battery
Improperly connecting or disconnecting battery cables can result in an explosion and cause serious
injury or death. When removing the battery, always disconnect the negative (black) cable first. When
reinstalling the battery, always connect the negative (black) cable last.
Your vehicle is equipped with a sealed battery, which
requires little maintenance. Always keep battery
terminals and connections free of corrosion. If cleaning
is necessary, remove corrosion with a stiff wire brush.
Wash with a solution of one tablespoon baking soda
and one cup water. Rinse well with tap water and dry
off with clean shop towels. Coat the terminals with
dielectric grease or petroleum jelly.
Battery Removal
1. Remove the seat. The battery is located under the
passengers side of the vehicle.
2. Disconnect the black (-) battery cable first.
3. Disconnect the red (+) battery cable last.
4. Remove the battery hold-down strap.
5. Lift the battery out of the vehicle.
Battery Installation
Using a new battery that has not been fully charged can damage the battery and result in a
shorter life. It can also hinder vehicle performance. Follow the battery charging instructions
on page 112 before installing the battery.
1. Ensure that the battery is fully charged.
2. Place the battery in the battery holder. Install the battery hold-down strap.
3. Coat the terminals with dielectric grease or petroleum jelly.
4. Connect and tighten the red (+) cable first.
5. Connect and tighten the black (-) cable last.
To Next Page
Loading...
Need help?
General
