EasyManuals Logo

Polaris BRUTUS User Manual

Polaris BRUTUS
136 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
34
OPERATION
Fuel Recommendations
NOTICE: For the best engine performance, to prevent engine damage and to comply with EPA/CARB
warranty requirements, use ONLY the recommended diesel fuels. Use only CLEAN diesel
fuel.
POLARIS recommends the following diesel fuels for use in this vehicle:
•Low Sulfur
Ultra Low Sulfur #2
#1 Diesel Fuel containing no more than 5% bio-diesel (see page 35)
See page 37 for cold weather fuel blend recommendations. For more information about
recommended diesel fuels and the consequences of using bio-diesel fuel exceeding 5% bio-
diesel, see Additional Technical Fuel Requirements below.
Diesel fuel should comply with the following world-wide specifications.
Additional Technical Fuel Requirements
The fuel cetane number should be equal to 45 or higher.
The sulfur content must not exceed 0.5% by volume. Less than 0.5% is preferred.
Especially in the U.S.A. and Canada, Low Sulfur (300 to 500 ppm (mg/kg) or Ultra Low
Sulfur fuel should be used.
Bio-Diesel fuels: see pages 35-36.
NEVER mix kerosene, used engine oil or residual fuels with diesel fuel.
Water and sediment in the fuel should not exceed 0.05% by volume.
Keep the fuel tank and fuel-handling equipment clean at all times.
Poor quality fuel can reduce engine performance and/or cause engine damage.
Fuel additives are not recommended. Some fuel additives may cause poor engine
performance.
Ash content must not exceed 0.01% by volume.
Carbon residue content must not exceed 0.35% by volume. Less than 0.1% is preferred.
Total aromatics content should not exceed 35% by volume. Less than 30% is preferred.
PAH (polycyclic aromatic hydrocarbons) content should be below 10% by volume.
Metal content of Na, Mg, Si and Al should be equal to or lower than 1 mass ppm (test
analysis method JPI-5S-44-95).
Lubricity: Wear mark of WS1.4 should be Max. 0.018 in. (460μm) at HFRR test.
Diesel Fuel Specification Location
ASTM D975
No. 1D S15, S500
No. 2D S15, S500
USA
EN590:96 European Union
ISO 8217 DMX International
BS 2869-A1 or A2 United Kingdom
JIS K2204 Grade No. 2 Japan
KSM-2610 Korea
GB252 China

Table of Contents

Other manuals for Polaris BRUTUS

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris BRUTUS and is the answer not in the manual?

Polaris BRUTUS Specifications

General IconGeneral
BrandPolaris
ModelBRUTUS
CategoryUtility Vehicle
LanguageEnglish

Related product manuals