60
OPERATION
Leveling The Ground Using Float
1. Raise the attachment arm (B) and tilt the bucket
forward (D).
2. Push the joystick all the way forward (AA) to
activate float.
NOTICE: Never drive forward when the attachment arm
is in the float position.
3. Drive backward to level loose material.
4. Pull the joystick backward (B) to unlock the
attachment arm from the float position.
Backfilling
1. Lower the attachment arm (A) and put the
cutting edge of the bucket on the ground (D).
Drive forward to the edge of the hole to push
the material into the hole.
2. Tilt the bucket forward (D) as soon as it is past
the edge of the hole.
3. If necessary, raise the lift arms to empty the
bucket.
To Next Page
Loading...
Need help?
General
