Polaris NEO EM27 - User Manual

H0771100_REVA
OWNER’S MANUAL
9400
NEO
™
Robotic Pool Cleaner
ENGLISH
|
FRANÇAIS
|
ESPAÑOL
TYPE EM27
WARNING
FOR YOUR SAFETY - For anything other than the routine cleaning and maintenance described in this manual, this product must be
serviced by a contractor who is licensed and qualified in pool equipment by the jurisdiction in which the product will be installed
where such state or local requirements exist. In the event no such state or local requirement exists, the maintainer must be a
professional with sufficient experience in pool equipment installation and maintenance so that all of the instructions in this manual
can be followed exactly. Improper installation and/or operation will void the warranty.

Polaris NEO EM27 Specifications

General

Cleaning Coverage	Floor, Walls, and waterline
Pool Type	In-ground
Cleaning Cycle	2.5 hours
Power Source	Electric
Cleaning Time	2.5 hours

Summary

Section 1. Important Safety Instructions

Section 2. Cleaner Specifications

Section 3. Assembly and Setup

3.1 Unpacking

Details on unpacking the robotic cleaner and its components.

3.2 Connecting to a Power Source

Instructions for safely connecting the cleaner's control unit to a power source.

Section 4. Operation

4.1 Cleaner Control Unit

Overview of the cleaner's control unit, including its buttons and indicators.

4.2 Submerging the Cleaner

Step-by-step guide on how to properly submerge the cleaner in the pool.

4.3 Starting the Cleaner

Instructions on how to select cleaning surface and begin operation.

4.4 Wall Climbing (Surface Control System)

Guidance on using the SCS for wall climbing and adjusting grip intensity.

4.5 Stopping the Cleaner and Removing from the Pool

Procedure for safely stopping the cleaner and removing it from the pool.

4.6 Cleaning the Filter Canister

Detailed steps for cleaning the filter canister after each use.

4.7 Storing the Cleaner

Proper methods for storing the robotic pool cleaner.

Section 5. Maintenance

5.1 Avoid Cord Tangling

Tips and procedures to prevent the floating cable from tangling.

5.2 Check for Brush Wear

How to check for brush wear indicators and replace worn brushes.

5.3 Replacing the Tracks

Guidance on when and how to replace worn tracks on the cleaner.

Section 6. Replacement Parts

Section 7. Troubleshooting

7.1 Using the Cleaner Error Indicator

Explanation of LED flashing sequences indicating cleaner malfunctions.

7.2 General Troubleshooting

Common problems, their causes, and solutions for operating the cleaner.