Page 4
English
Section 2. Cleaner
Specications
Control box
supply voltage
100-125 VAC, 60 Hz
Supply voltage 30 V DC
Installed load 150 W max
Cable length 50 ft (15 m)
Cleaner size
(WxDxH)
16 x 16.5 x 10 in. (41 x 42 x 25 cm)
Weight of
Cleaner
20 lbs. (9 kg)
Filtration All-purpose filter canister
Cycle lengths 1.5 hr
The cleaner power supply is double-insulated.
A double-insulated electrical appliance is one which has
been designed in such a way that it does not require a
safety connection to ground. Therefore, devices having
double-insulated construction, such as this cleaner, do
not utilize a grounded (three-prong) cord/plug.
Section 3. Assembly and Setup
3.1 Unpacking
The packaging should contain the following items:
• Robotic cleaner and floating power cable
• Control unit with power cord
• Control unit base
To protect the control unit from possible damage
(which could lead to injury or property damage),
always secure the control unit to the control unit
base during operation and storage.
When unpacking the cleaner and its components:
• Check to make sure each component is in the box.
• Check cleaner and components for damage.
• If there are missing parts or damage, contact
Polaris Technical Support:
USA 1-800-822-7933
Canada 1-888-647-4004
3.2 Connecting to a Power Source
WARNING
Failure to comply with the following warnings can result in
permanent injury, electrocution or drowning.
PREVENT ELECTRICAL SHOCK
• U.S.: Per NEC
®
requirements, keep the control unit
at least ve (5) ft. (1.5 m) from the edge of the pool.
CANADA: Per CEC
requirements, keep the control unit
at least three (3) m (10 ft.) from the edge of the pool.
• Only connect the control unit to a receptacle protected
by a ground fault circuit interrupter (GFCI). Contact
a certied electrician if you cannot verify that the
receptacle is protected by a GFCI.
• Do not use an extension cord to connect the control unit.
• Do not allow anyone to swim while the cleaner is in the
pool.
• The control unit is water-resistant, not waterproof. In
order to prevent electrocution, never submerge the
control unit or leave exposed to inclement weather.
To Next Page
Loading...
Need help?
General
