Page 6
English
4.1 Cleaner Control Unit
4.2 Submerging the Cleaner
1. Submerge the cleaner vertically (1) and hold it
under the surface, moving gently from side to
side (2) until the bubbles stop to remove any air
trapped inside.
2. When the bubbles stop, allow the cleaner to
sink to the bottom of the pool.
3. Verify the cleaner is sitting on the bottom
of the pool. Remove additional air if the cleaner
is still oating.
NOTE: The handle of the cleaner remains up whether the
cleaner is OFF or ON.
4. Spread the oating cable over the pool, making
sure there are no kinks or coils in the cable .
NOTE: For optimal patterning and reduced tangling, the
floating cable should enter the water near the middle
of the pool length. Only place enough cable in the
water to reach the farthest point in the pool.
SURFACE CONTROL SYSTEM
1 2 3 4ROUGH SMOOTH
Select Cleaning Surface
• Floor
• Floor and Walls
Start/Stop
Cleaner
Cleaner Error
Indicator
Surface Control
System™ (SCS)
for wall cleaning
(rough to smooth
surfaces)
LEDs indicating
pump strength for
SCS
1
2
Figure 4. Submerge and Remove Trapped Air
To Next Page
Loading...
Need help?
General
