75
MAINTENANCE AND LUBRICATION
Polaris Var iable Transmission (PVT) S ystem
WARNING
Failure to comply with the instructions in this warning can result in
severe injury or death.
Do not modify any component of the PVT system. Doing so may
reduce its strength so that a failure may occur at a high speed.
The PVT system has been precision balanced. Any modification
will cause the system to be out of balance, creating vibration and
additional loads on components.
The PVT system rotates at high speeds, creating large amounts
of force on clutch components. Extensive engineering and
testing has been conducted t o ensure t he safety of this product.
However, as the owner, you have the following responsibilities to
make sure this system remains safe:
Always follow all recommended maintenance procedures. See
your dealer as outlined in the owner’s manual.
This PVT system is intended for use on Polaris products only. Do
not install it in any other product.
Always make sure the PVT housing is securely in place during
operation.
PVT Drying
There may be some instances when water is accidently ingested i nto
the PVT system. Use the following instructions to dry it out before
operating.
1. Shift t he transmission into neutral and apply full throttle for no
longer than 10 seconds and repeat as necessary. This wi ll expel t he
moisture and air dry the b elt and clutches.
2. Allow the engin e RPM to settle t o idle speed, then shift t he
transmission to the lowest available range.
3. Test for belt slippage. If the belt slips, repeat the process.
4. Take the vehicle t o your dealer for service as soon as possible.
To Next Page
Loading...
Need help?
General
