1
2
1
2
TM
6X6
4X4
70
MAINTENANCE AND LUBRICATION
Gearcases
Rear Gearcase
Always check and change the rear gearcase oil at the intervals outlined
in the Periodic Maintenance Chart beginning on page 54. Maintain the
oil level even with t he bo ttom thread of the fill plug hole. We
recomm end th e use of Polaris ATV Angle Drive Fluid. See page 99
for the part numbers of Polaris products.
The rear gearcase fill plug (1) is on the driver’s s ide of the rear
gearcase.
Oil Check
1. Position the vehicle on a level
surface.
2. Remove the fill pl ug and
check the oil level.
3. Add the recommended
fluid as needed.
4. Reinstall the fill plu g. Torque
to specification. See page 66.
Oil Change
1. Remove the fill pl ug.
2. Remove the drain plug (2)
from the bottom of the
gearcase and drain t h e oil
into a drain pan. Discard
used oil properly.
3. Clean and reinstall the drain
plug. Torque to specification.
See page 66.
4. Add the recommended fluid.
Refer to t he Gearcase
Specifications Chart on page
66.
5. Reinstall the fill plu g. Torque
to specification. See page 66.
6. Check for leaks.
To Next Page
Loading...
