13
Follow below steps to configure S100 to receive correction data from third-party NTRIP client app like
Lefebure NTRIP Client, via Bluetooth. The Polaris Connect app closes as soon as the S100 starts to work
as Bluetooth RTK rover.
1. Switch to Rover tab in the app. See Figure 4-5 a
2. Click Start of “Bluetooth Rover”; the app Polaris Connect will be closed. See Figure 4-5 b
3. Start third-party NTRIP client app to receive RTK correction data, sends it to S100, and receive
position data stream from S100. See Figure 4-5 c.
4. If needing more information on how to use Lefebure NTRIP client app, refer to Appendix A-2-4.
a b c
Figure 4-5
To Next Page
Loading...
Need help?
General