Polaris S100 - A-2-1 Bluetooth RTK Base with App-Built-In NTRIP Server

37
A-2-1 Bluetooth RTK Base with App-Built-in NTRIP Server
The S100 RTK Receiver, when configured as a Bluetooth RTK base, can output RTK correction data with
the NTRIP server built inside the “Polaris Connect” app, as shown in Figure A-5.
Figure A-5
Follow below steps to configure S100 to send out RTK correction data via Bluetooth with built-in
NTRIP server.
1. Click Base tab. See Figure A-6 a
2. Click Settings (Figure A-6 b) and configure NTRIP log-in information (Figure A-6 c).
3. Click Start of “Bluetooth Base with NTRIP Server”. See Figure A-7 a.
4. The NTRIP server starts. See Figure A-7 b.