113
MAINTENANCE AND LUBRICATION
Lights - Adjustment - Replacement
Headlight Housing Replacement
1. Remove Phillips screws from bottom of headlight pod at each front
corner. NOTE: To aid in accessing these screws, it may be helpful
to turn handlebars to left or right and use a short, stubby screwdriver.
Removal of the front rack and cover may also allow easier access.
2. Remove three P hillips screws at
back of headlight pod.
3. Lift pod cover up. Disconnect
speedometer harnesses from
speedometer. Unplug indicator
light harness and remove pod cov-
er.
4. Unplug headlamp from wiring har-
ness.
5. Remove O-Ring from headlight
pivot pins.
6. Pull headlight housing up to re-
lease from locking tabs.
7. Lift adjusting knob up to remove
from locking tabs.
8. Carefully pull assembly up and out
of pod.
9. Reverse steps to install new hous-
ing and reassemble pod.
10.Adjust headlight aim by turning
adjusting knob.
O-Ring
51/8″
(13 cm)
Distance from headlamp parting
line to end of adjustment knob stop
is 5 1/8″ (13 cm).
To Next Page
Loading...
