50
OPERATION
Vehicle Break-in Period
The break-in period for your new Polaris 6x6 is defined as the first ten
hours of operation or the time it takes to use the first two tanks of
gasoline. No single action on your part is as important as a proper
break-in period. Careful treatment of a new engine will result in more
efficient performance and longer life for the engine. Perform the
following procedures carefully.
1. Fill fuel tank with either unleaded or leaded fuel which has a mini-
mum pump octane number of 87= (R+ M)/2.
2. Check oil reservoir lev-
el indicated on dipstick.
Add oil if necessary.
3. Drive slowly at first.
Select an area which is
open and will give you room to familiarize yourself with vehicle
operation and handling.
4. Vary the throttle positions. Do not operate at sustained idle.
5. Perform regular checks on fluid levels, controls and all important
areas on the vehicle as outlined earlier on the daily pre-ride inspec-
tion checklist found on page 12.
6. Pull only light loads.
7. Break in oil and filter. Change at 20 hours or 200 miles.
CAUTION
Use only Polaris Premium 4 All Season synthetic oil, or API certified
“SH” oil. Never substitute or mix oil brands. Serious engine
damage and voiding of warranty can result.
ADD 8 OZ. NORMAL FULL
Maintain Oil Level In Normal Range
CAUTION
Do not operate at full throttle or high speeds for extended periods
during the first three hours of use. Excessive heat can build up and
cause damage to close fitted engine parts.
To Next Page
Loading...
Need help?
General
