• Using Flash
When taking pictures in difficult lighting conditions, use the Flash to get the
correct exposure. This function cannot be activated when recording movies
or continuous shooting.
SET
DISP
Flash button
To activate the Flash
• Press the Flash/Right button on your
camera repeatedly until your desired flash
mode is displayed on the LCD display.
Your camera is equipped with five flash modes:
Auto. The flash fires automatically
whenever extra lighting is needed.
Red-eye reduction. The flash fires
twice to reduce the red-eye effect.
Always on. The flash fires whenever
you press the shutter button regardless
of lighting conditions.
307307
10M
Auto flash is enabled.
Slow sync. The flash fires with a delay and uses slow shutter speed.
Off. The flash is turned off.
NOTE:
• Flash function is only available in shooting still images but not available in Burst
and AEB modes.
• Do not charge the flash while pressing the zoom button. Charge the flash after
releasing the zoom button if necessary.
Zoom buttons
To Next Page
Loading...
Need help?
General
