• Setting Power Save
The Power Save function allows you to set an idle time after which the camera
automatically sets to sleep mode to save power. After a minute of being in
the sleep mode, the camera eventually turns off power.
Available settings are: 1, 3, or 5 min.
This function is not available as follows:
• Recording a movie or audio file
• Playing a slideshow/movie/audio file
• Using the USB connector.
• Setting LCD Save
Enable the LCD Save function to automatically decrease the LCD brightness
to conserve battery power. When the camera is idle for 20 seconds, the LCD
darkens. Press any button to resume to normal brightness.
• The camera is idle when no buttons are
pressed. LCD Save, though enabled,
does not function during movie playback,
slideshow, and video recording.
• Setting Date & Time
Use the Date & Time function to set the date
and time of your camera. This function is useful
attaching date stamps on captured images. Your
camera uses a 12-hour time format.
1. Press the navigation controls to adjust date and
time value. By holding down the or
keys,
the numeric values change continuously.
2. Press OK to apply changes.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
