Using Remote Control
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
To return back to the previous channel viewed
• Press the “
SWAP
” button to review the previous channel.
To turn on or turn off the close captioning
• Press the “
CCD
” button to turn ON or turn OFF close caption function.
To change the picture effect
• Press the “
PP
” button to select the picture effect.
• There are four modes for picture with different effect.
User
(The picture brightness/contrast/color/sharpness is preset by user)
Standard
(Fixed mode for normal condition)
Dynamic
(Fixed mode for day time with high brightness environment)
Mild
(Fixed mode suitable for bedroom without light condition)
To set the sleep time
• Press the “
SLEEP
” button to select a predetermined time the TV will turn off. The sleep time can
be set to count down from 15 to 240 minutes.
To mute the sound
• Press the “
MUTE
” button to mute the sound, press once again to resume the sound.
To select Input mode
•
Press the “
INPUT
” button to select source model.
AUTO POWER OFF
If no signal is continuously detected from the antenna or broadcasting for more than 10
minutes, the TV will power-off automatically.
Operating Your TV
!!!!!!!
!!!!!!
!!
!!!!!!!!!!
!!!!!!!!
Once you have connected your TV to an antenna or cable system, plugged the TV in, and put bat-
teries in the remote, you are ready to use the TV. The first thing you should do is program your TV to
memorize all of the available channels in you area.
Turning Your TV On
To turn your TV ON, press the “
” button on the remote control or press the “ ” button on the front
panel. (The LED light is red when the TV is in the standby mode and blue when powered up.)
There are 3 option in initial setup menu:
•
Menu Language
: English, Francais, Espanol
•
Signal type
: Air, Cable
•
Auto Channel Search:
Execute
•
Press the “
/
” button to highlight desired menu
language or signal type and press the “
/
” but-
ton to select desired menu language and signal
type.
•
Press the “
/
” button to highlight
Auto Channel
Search
and press “
ENTER
” button to perform
auto channel scan, the Auto Scan process will
take about 30 minutes, while the auto scan pro-
cess is finished then the first memorized channel
will appear on the screen.
You can Scan for channels at any time using the
following instructions:
Channel Programming
1 Press the “
MENU
” button on the remote control,
then press the “
/
” button to highlight
CHANNEL
.
and press the “
ENTER
” button to access to the
sub-menu.
There are 6 items in
CHANNEL
Sub-menu:
•
Channel Number
•
Signal Type
•
Auto Channel Search
•
Channel List
•
Channel Label
•
Channel Skip
First time installation
When you power ON the unit for the first time, the screen will show the initial setup dialog.
LED-2212 Polaroid Eng IB.indd 16-172010/9/28 上午 10:18:09
To Next Page
Loading...
Need help?
General