27
When a signal is received on one channel among the three the unit
will pause for about 5 seconds before resuming the triple watch.
To activate the triple watch mode, rst select a radio channel (see
Channels) as the primary channel and select one priority channel.
Press and hold the Dual Watch and Triple Watch button.
To deactivate the triple watch press and hold the Dual Watch and
Triple Watch button again.
Pressing the Dual Watch and Triple Watch button briey will lead to
the dual watch mode.
If you press the PTT button whilst receiving a signal in dual watch or
triple watch mode the radio will transmit on the currently displayed
channel.
If you press the PTT button when no signal is present the radio will
transmit on the primary channel. dual watch and triple watch will
resume approximately 5 seconds after the transmission
Channel Scan
The Channel Scan can be used to nd or detect users on other radio
channels.
To activate/deactivate the channel scan, press the Scan button briey.
The Scan icon will appear when the channel scan is active.
Scanning will only stop when you deactivate the scan function.
The radio will
scan through the whole marine band channels.
If your radio detects a valid signal the scan will pause for about 5
seconds.
If you press the PTT button when your radio detects a signal, the
radio will transmit on the same channel.
Press the UP or DOWN button to resume scanning immediately. If
you press the PTT button during scanning, the radio will return to
your original channel.
Scanning will resume approximately 5 seconds after the transmission.
While one Priority Channel has been selected in the Function Menu,
only the Priority Scan is available. The selected Priority Channel is
visited as frequently as the scanning channel changes.
To Next Page
Loading...
