▪ Static: Specify the following IP settings manually (available options vary with your
selections):
Field Description
IP Address Specifies the Ethernet IP address.
Netmask Specifies the Ethernet subnet mask.
Gateway Displays the default gateway assigned to the
EagleEye Cube USB device.
If the camera doesn’t automatically obtain a
gateway IP address, enter one here.
DNS Address 1 Specifies the DNS server IP address.
DNS Address 2 Specifies the alternate DNS server IP address.
Domain The domain name assigned to the EagleEye
Cube USB device.
If the camera doesn’t automatically obtain a
domain name, enter one here.
5. Select Save.
Related Links
Initialize the EagleEye Cube USB Device Using the Setup Wizard on page 26
Configure Ethernet 802.1x Settings
You can configure Ethernet 802.1x security settings.
Procedure
1. Connect the EagleEye Cube USB device to your computer, then select the Poly EagleEye Cube
tile in Polycom Companion.
2. Go to Admin Settings > Network Settings > Network and select Ethernet from the drop-down
list.
3. Select 802.1x Security Settings.
4. Configure the following settings (available settings may vary with your selections):
Setting Description
Security Specifies the encryption protocol:
▪ None
▪ 802.1x EAP
EAP Method Specifies the EAP for WPA-Enterprise
(802.1xEAP):
▪ PEAP
▪ TTLS
▪ MD5
Managing the EagleEye Cube USB Device
37
To Next Page
Loading...
Need help?
General
