Setting Description
Phase 2 Authentication Specifies the phase 2 authentication method.
Available options vary with the selected EAP
method.
▪ MSCHAPV2
▪ GTC
Identify Specifies your identity.
Anonymous Identify Specifies an anonymous identity to protect your
real identity.
Password Specifies the login password.
Related Links
Initialize the EagleEye Cube USB Device Using the Setup Wizard on page 26
Configure a Provisioning Server for the EagleEye Cube USB Device
You can configure a provisioning server for the EagleEye Cube USB device through Polycom Companion.
Make sure that the EagleEye Cube USB device connects to an Ethernet connection before connecting
the EagleEye Cube USB device to a provisioning server.
Procedure
1. Connect the EagleEye Cube USB device to your computer, then select the Poly EagleEye Cube
tile from your Polycom Companion.
2. Go to Admin Settings > Provisioning Server.
3. Select Provisioning Mode and choose one of the following options:
▪ Disable: Disables the provisioning mode.
▪ Manual: Configure the following parameters:
Parameter Description
Server Address Specifies the server address.
User name and Password Specifies the user name and password to log in
to the provisioning server.
▪ Auto: Retrieves the provisioning server address from the DHCP Option and the EagleEye
Cube USB device reports the DHCP option to Polycom Companion.
You can enter a DHCP value from 140 to 207 or leave this field blank. If you leave the field
blank, the system uses the default DHCP value. The default DHCP value is 160.
4. Select Save.
You can check the provisioning status in Status > Provisioning Server.
Related Links
Initialize the EagleEye Cube USB Device Using the Setup Wizard on page 26
Managing the EagleEye Cube USB Device
38
To Next Page
Loading...
Need help?
General
