PSTN Mode
After you connect your phone for PSTN use and start it for the first time, your phone will
automatically prompt you to enter certain information.
To set up the phone for PSTN use:
After your phone starts for the first time, the Select Country screen automatically displays, as
shown next. Use the Down Navigation key to select the country your phone operates in, and
then press the Select soft key.
After you select the country, the Select Language screen displays, as shown next. Use the
Down Navigation key to select the language you want your phone to display, and then press
the Select soft key.
After you enter the country and language, your phone updates its settings and displays the
idle screen, as shown next.
To configure more advanced settings, see the Administrator’s Guide for the Polycom
UC Software available from the
Polycom recommends that you upgrade the software on the
phone so it uses the latest version.
To upgrade the phone’s software:
1. Log in to the Web Configuration Utility as an administrator.
The default password for an administrator is 456.
2. From the Main Menu, select Utilities, and then select
Software Upgrade.
3. From the Software Upgrade screen, choose to look for
software from either the Polycom Server or a specified
Custom Server.
4. Click Check for Updates to display the available software
versions on the specified server.
5. From the drop-down list, select a software version.
6. To install the software, click Install.
Note: If you are unable
to upgrade your phone’s
software, see your
network administrator
or the Administrator’s
Guide for the Polycom
UC Software.
Upgrading Your Phone’s Software
SoundStation Duo Support web page.
To Next Page
Loading...
