Polycom SoundStation2W - Bridge Soft Key Configuration; Programming the Bridge Number; Editing the Bridge Soft Key Label

SoundStation2W™ User Guide - 18
Bridge Soft Key
You may program the telephone number of your
preferred conferencing bridge vendor into the
SoundStation2W™ so that it is immediately
available.
Programming the Bridge number
1. Press the Menu button, choose
Bridge Setup using the Scrolling
buttons, and press the Select but-
ton.
2. Choose Enter Phone Number and
press the Select button and then en-
ter the bridge number using the dial
pad. Enter any necessary prefix
such as 9 and/or 1.
► If you make a mistake entering the
number, use the <DEL soft key to
correct the error.
3. Press the SAVE soft key or CANCEL
soft key
if you wish to cancel the
procedure.
Editing the Bridge soft key
1. Press the Menu button, choose
Bridge Setup using the Scrolling
buttons, and press the Select but-
ton.
2. Choose EDIT soft key, press the
Select button and enter the new soft
key label using the dial pad. The
first six characters will display.
► If you make a mistake entering the
soft key label, use the <DEL soft
key to correct the error.
3. Press the SAVE soft key or CANCEL
soft key
if you wish to cancel the
procedure.
►The SPEED DIAL soft key will
not display when the bridge
number is configured.
Dit document wordt u aangeboden door TelecomHunter. Dé zakelijke Telecom webshop.
T 088 7463 444 | @ sales@TelecomHunter.nl | www.TelecomHunter.nl