Poly VVX Series Self-installation and Configuration Guide 5
CONNECT OPTIONAL EXPANSION MODULES, HEADSET, OR USB DEVICES
Expansion Modules can be connected to the AUX port from the phone to the module. You can connect up
to 3 expansion modules.
Your phone supports wired and may support wireless headsets, including EHS headsets. VVX 601
phones also support Bluetooth headsets. To learn more about compatible headsets for your set, see
Compatible Headsets on sasktel.com/ibcsupport.
For connection directions, refer to your headset documentation. Standard headsets typically use the RJ-9
or USB port (only available in VVX 401, 501 or 601), while EHS headsets use the RJ-9 and serial port.
The ports are on the back of the phone, as shown below.
CONFIGURING YOUR SET
1. Once you have connected to a network and a power source, the phone will upgrade firmware and
reboot several times. This could take 5 to 15 minutes. When the phone is ready to continue, it will
have a QSetup softkey.
To Next Page
Loading...
