8. Do not plug in the filter pump at this point. Begin to fill water until the water
level reaches the fill line.
5. Connect the Hose 5 form the Suction Fitting 6 to the Filter Pump
Inlet.
6. Connect the Hose 5 form the pool Return Fitting to the Filter Pump
outlet.
7. Tighten all Hose Clamps 6 to prevent water leakage.
9. Air is now trapped inside the Filter Pump system, which will prevent the
water from flowing smoothly. To VENT the system (release the
trapped air), open the Vent Screw 8 at the top of the pump by turning
it counter-clockwise. The water pressure will force out all the trapped
air inside the Filter Pump system. Tighten the Vent Screw 8 when
you see water flowing out from the Seal Top 10 .
10. Adjust the Return Fitting Diverter 3 to maximize the circulation of the
pool water.
3
4
5
6
10
8
10
8
5
6
11
OWNER’S MANUAL
To Next Page
Loading...
