Polygroup RX330 - SETUP INSTRUCTIONS; Before Using the Pump; Vent the Pump; Optimize Water Circulation

11
OWNER’S MANUAL
Before Using the Pump
8. You can now fill the pool with water up to the FILL LINE.
Do NOT plug the Pump in at this point.
7. Tighten all the Clamps
q
to prevent water leakage.
9. Vent the Pump: to release the air trapped inside and make sure a
smooth water flow, it’s important to vent or depressurize the Pump
before each use. Simply twist counterclockwise to loosen the Vent
Screw
e
, and the water pressure will force all the trapped air out.
Retighten the Screw when water starts flowing out.
10. To optimize water circulation, twist the RF Diverter
7
so that it faces
down and away from the Suction Fitting.
7
360°
4
9
10
Inside Pool Wall
9
6
14
12
14
12
6. Connect the Return Fitting
6
to the Pump outlet with another Hose
and one Clamp on each end.
9
10
2
5. Connect the Suction Fitting
2
to the Pump inlet with a Hose and
one Clamp on each end.
Fill Line