EasyManua.ls Logo

Polytropic PAC 22 - User Manual

Default Icon
108 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Handbook PAC / R-PAC User 2009 rel. 9.8 (07/2009)
PAC 16 / 22 / 31 & R- PAC 16 / 22 / 31
Français: p. 3
English: p. 27
Español: p. 51
Deutsch: s. 75

Table of Contents

Questions and Answers

  • M
    Mrs. Whitney Blackburn MDAug 8, 2025
    Why is my Polytropic Heat Pump not heating the pool water effectively?
    • K
      kevin23Aug 8, 2025
      There are several reasons why your Polytropic Heat Pump might not be heating the pool water effectively. It could be that the heat pump is too small for the pool or the current season. Another potential cause is that the by-pass needs adjustments. Refer to the water setting chapter of this handbook for instructions. Finally, the absence of a pool cover can also slow down the heating process; installing a solar cover may resolve this issue.
  • L
    Laura DelgadoAug 18, 2025
    What to do if there is no digital display ignition on my Polytropic Heat Pump?
    • C
      Carla WardAug 18, 2025
      If your Polytropic Heat Pump's digital display isn't igniting, several factors could be at play. First, check if the relay is properly connected to terminals “1” and “5”; if not, connect or install the relay. For tri-phase heat pumps, a phase error might be the cause; try inverting two phases and checking again. Lastly, the LP pressure controller might have cut off; in this case, wait until the water temperature exceeds 15°C.
  • S
    Samantha CarrollAug 28, 2025
    How to fix a Polytropic Heat Pump when the fan is running but the unit isn't working?
    • M
      Michael EscobarAug 28, 2025
      If the fan in your Polytropic Heat Pump is running but the unit isn't working, it might be in defrost mode. Once the ambient temperature rises above 7°C, the heat pump should start working.

Summary

Warning and General Information

Personnel, Standards, and Safety

Qualified Personnel Requirements

Installation, handling, and repairing should only be carried out by qualified engineers.

Hydraulic Connection

By-pass Connection Setup

Heat pump connects to filtration circuit via a by-pass, requiring specific valve placement.

Electrical Connection Requirements

Voltage, Current, and Cable Sizing

Electric supply voltage/current must match, cables sized correctly, and 30mA differential protection used.

Mono-phase Electrical Connection Diagram

Wiring Diagram for Mono-phase Units

Tri-phase Electrical Connection Diagram

Wiring Diagram for Tri-phase Units

PAC Models Temperature Regulation

Setting Water and Defrost Temperatures

PAC Model Error Messages

Common Error Codes and Meanings

R-PAC Model Digital Controller Overview

Water Flow Settings and Management

Pool Heating Process

Troubleshooting Common Issues

Fault Diagnosis and Solutions Table

A table listing common faults, probable causes, checking methods, and answers for heat pump issues.

Technical Support and Service Information

PAC Models Technical Data

PAC16, PAC22, PAC31 Specifications

Technical data for PAC16, PAC22, PAC31 models including power, flow, noise, dimensions, and weight.

R-PAC Models Technical Data

R-PAC16, R-PAC22, R-PAC31 Specifications

Technical data for R-PAC16, R-PAC22, R-PAC31 models including power, flow, noise, dimensions, and weight.

Polytropic PAC 22 Specifications

General IconGeneral
BrandPolytropic
ModelPAC 22
CategoryHeat Pump
LanguageEnglish

Related product manuals