POOLEX MAG - Use; Control Panel; Heating; Cooling; Automatic Mode

FR | 13
EN
4. USE
4.1 Control panel
4.2 Heating / Cooling / Automatic mode
Before use, ensure that the ltration pump is working and that water is circulating
through the heat pump.
Prior to setting your required temperature, you must rst select an operating mode for your
remote.
Cooling mode
Select the cooling mode if you want to heat up the tub
water with the heat pump.
Automatic mode
Select the automatic mode if you want to let the heat
pump switch to the correct mode in a smart way
according to the target temperature.
Heating mode
Select the heating mode if you want to heat up the tub
water with the heat pump.
Heating mode
“Mode” button
"ON/OFF” button
WiFi indicator
“High” button
“Low” button
Cooling
mode
Heater pilot indicator (RECH
indicator)
Circulation pump
indicator
Automatic mode