9 - ENG
ASSEMBLE AIR INTAKE FILTER (FIG. 2)
Risk of unsafe operation. Do not operate without air intake filter.
Remove shipping plug (U) from air intake inlet and assemble air intake filter(P). Tighten
until snug.
FIG. 2
P
U
INSTALLATION
HOW TO SET UP YOUR UNIT
LOCATION OF THE AIR COMPRESSOR
• Locatetheaircompressorinaclean,dryandwellventilatedarea.
• Theaircompressorshouldbelocatedatleast12"(30.5cm)awayfromthewall
or other obstructions that will interfere with the flow of air.
• Theaircompressorpumpandshroudaredesignedtoallowforpropercooling.
The ventilation openings on the compressor are necessary to maintain proper
operating temperature. Do not place rags or other containers on or near these
openings.
• Keepthecompressorawayfromtheareasthathavedirtand/orvolatilefumesin
the atmosphere. These impurities may clog the air intake filter and valves, causing
inefficient operation.
• Placetheaircompressoronaflatsurfacerestingontherubberfeet.
NOISE CONSIDERATIONS
Consult local officials for information regarding acceptable noise levels in your area.
To reduce excessive noise, use vibration mounts or silencers, relocate the unit or
construct total enclosures or baffle walls. Contact a Trained Service Technician for
assistance.
ELECTRICAL (FIG. 4)
Refer to all safety instructions before using unit. Observe extension cord safety
instructions if necessary. Always move the Auto/Off switch (D) to the "Off" position
before removing the plug from the outlet.
TRANSPORTING
Whentransportingthe compressor in avehicle, trailer, etc.,ensure thatthe tank is
drained and the unit is secured. Use care when driving to avoid tipping the unit over
in the vehicle. Damage can occur to the compressor or surrounding items if the
compressor is tipped.
MOVING
Whenmovingthecompressor,graspthehandleandcarrythecompressorasclose
to the body as possible.
Risk of unsafe operation. Ensure proper footing and use caution when
carrying compressor to avoid a loss of balance.