Porter-Cable PCFP02040 - Service; Replacement Parts; Service and Repairs; Accessories

17 - ENG
3. Protect the electrical cord and air hose from damage (such as being stepped on
orrunover).Windairhoselooselyaroundthecompressorhandle.
4. Store the air compressor in a clean and dry location.
SERVICE
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our
service website at www.portercable.com You can also order parts from your nearest
PORTER-CABLE Factory Service Center or PORTER-CABLE Authorized Warranty
Service Center. Or, you can call our Customer Care Center at 1-888-848-5175.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For information
about PORTER-CABLE, its factory service centers or authorized warranty service centers,
visit our website at www.portercable.com or call our Customer Care Center at 1-888-848-
5175. All repairs made by our service centers are fully guaranteed against defective material
andworkmanship.Wecannotguaranteerepairsmadeorattemptedbyothers.
You can also write to us for information at PORTER-CABLE, 4825 Highway 45 North,
Jackson, Tennessee 38305 - Attention: Product Service. Be sure to include all of the
information shown on the nameplate of your tool (model number, type, serial number, etc.).
ACCESSORIES
Since accessories, other than those offered by PORTER-CABLE,
have not been tested with this product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only PORTER-CABLE recommended accessories
should be used with this product.
A complete line of accessories is available from your PORTER-CABLE Factory Service
CenteroraPORTER-CABLEAuthorizedWarrantyServiceCenter.PleasevisitourWebSite
www.portercable.com for a catalog or for the name of your nearest supplier.
TROUBLESHOOTING
Risk of Unsafe Operation. Unit cycles automatically when
power is on. When servicing, you may be exposed to voltage sources,
compressedair,ormovingparts.Beforeservicingunitunplugordisconnect
electricalsupplytotheaircompressor,bleedtankofpressure,andallowthe
air compressor to cool.
PROBLEM CAUSE CORRECTION
Excessive tank
pressure - safety
valve pops off.
Pressure switch does
not shut off motor when
compressor reaches
"cut-out" pressure.
Move Auto/Off lever to the "Off"
position, if the outfit does not
shut off have checked by a
Trained Service Technician.
Pressure switch
"cut-out" too high.
Have checked by a Trained
Service Technician.