21
11. Camera Manual/Auto Mode
Manual Mode: Tap to manually adjust ISO, shutter time, white balance, and set the parameters by
observing the exposure value(EV)
Auto Mode
10. Shooting Information Display/Settings
Photo Mode: displays photo format, EV (exposure value) and the remaining numbers of photos
or the available capacity of the current microSD card.
Video Mode: displays video resolution, EV (exposure value) and the remaining video recording
time or the available capacity of the current microSD card.
Tap WB 5000K to set white balance.
Tap SS 1/100 to set camera SS (shutter speed).
Tap ISO 800 to set ISO (light sensitivity).
Manual Mode:
Tap WB 5000K to set white balance.
Tap SS 1/100 to set camera SS (shutter speed).
Tap ISO 800 to set ISO (light sensitivity).
Manual Mode:
Calibration
This sector includes compass calibration, gimbal calibration, gimbal fine-tunning, remote controller calibration and
drone re-pairing.
Camera
General Settings: Tap to set white balance, gridlines, segmental recording, etc. Tap to check microSD card
capacity and format.
Other Settings: Tap to set watermarks and add GPS coordinates in photos.
About
View device information, firmware information, App version, etc.
Tap to switch between the display of the
remaining numbers of photos or the available capacity
of the current microSD card.
Tap to set EV.
Tap JPG to set photo format to JPG or RAW+JPG.
Auto Mode:
Tap 4K 30 to set video resolution and frame rate.
Auto Mode:
4K: 30/25/24fps, 2.7K: 30/25/24fps, 1080P: 60/50/30/25/24fps
Tap to switch between the display of
the remaining video recording time or the available
capacity of the current microSD card.
Tap to set EV.
12. Interval Timer Shooting Mode:
Control
Remote Controller Settings: Tap to switch control stick mode (Mode 1: Left Hand Throttle; Mode 2: Right Hand
Throttle)
Gimbal Settings: Tap to set gimbal maximum pitch speed, gimbal angle (0°/-90°), and to switch between Gimbal
Stable Mode or FPV Mode.
In Interval Timer Shooting Mode, the camera will take photos at a selected time interval continuously.
Conditions to activate the Interval Timer Shooting Mode: camera set to Photo Mode and the image
format to JPG.
Long press the icon to start the timer dial. Choose the time interval then tap or click the photo
button on the remote controller to start taking photos. Tap to cease shooting, and tap again to
exit Interval Timer Shooting Mode.
To Next Page
Loading...
