Method 1: Tap on the left of App to exit RTH.
Method 2: Briefly press the return button on the remote controller to exit RTH.
One key RTH: Press and hold the RTH button on the remote controller for 1s or tap in App to pop up the
menu, then swipe right to start the return.
Auto RTH: When either the drone battery level is low, the signal between the drone and the remote controller is
lost or the drone is experiencing other abnormalities, Auto RTH will be triggered.
7.8 Return(RTH)
The regular return consists of three steps, as follows:
To ensure the safety of the return flight, please set the appropriate return altitude in the app according to the
flight environment.
During the return course, users can still adjust the flight altitude by adjusting the throttle.
The drone will return when it is within 20m of the HOME point, and the return altitude will be 5m. Please pay
attention to safety.
Tall buildings or obstacles can block the transmission signal and cause signal loss. Do not fly behind
buildings beyond the return altitude, otherwise the drone will collide with obstacles and crash during the
return. If the drone enters ATTI mode due to GPS failure or GPS signal interference, it will not be able to return.
During the return process, strong headwinds may be encountered. Lowering the flight altitude Appropriately
can help reduce power consumption. If the power is insufficient, the drone will perform a forced landing in
place. Please pay attention to the prompts in PotensicPro App. Do not initiate the return when there are
obstacles overhead, such as tall trees, otherwise the drone may crash during the climb.
If there are obstacles in the surrounding environment and it's not suitable to return, it is recommended to keep
the drone hovering or land the drone after losing signal in Settings to avoid colliding with the obstacles during
RTH.
30
1. Ascent: The drone ascends to the set return altitude (this step is skipped if the drone's altitude is already
higher than the return altitude).
2. Level flight: The drone maintains a straight flight at the set altitude towards the HOME point.
3. Landing: Once it reaches the HOME point, the drone will automatically land and stop its propellers.
How to exit RTH
RTH Requirements
The drone must take off in GPS mode and successfully record the HOME point.
If the drone takes off in OPTI mode and switches to GPS mode mid-flight, it will not be able to return to the
takeoff point.
Please pay attention to the location of the HOME point on the map and the prompts in PotensicPro App.
Return to Home (RTH) The drone must be in GPS mode
＞20m
Return ascent
If Drone altitude ≥ return
altitude, start from step 2
Return altitude = Your settings
Return flight
Landing
1
2
How to Start RTH
H
3
7.8.1 Regular Return
To Next Page
Loading...
