34
8.4 Remote Controller Calibration
8.4.1 When to perform remote controller calibration
1. When the drone drifts automatically in one direction without any toggling of the control sticks.
2. When the drone auto-rotating sideway continuously.
3. When the control sticks are over-sensitive or lack sensitivity.
8.4.2 Calibration Procedure
1. Turn on the remote controller, and connect the mobile device, tap Settings in the App, select “Remote
Controller Calibration”.
2. Make sure the control sticks are in the middle position and do not operate it before tapping to start the
calibration.
3. Tap “Start Calibration”, then follow the on-screen instructions and toggle the sticks in all directions until 100%
is displayed in the app interface, and then maximum toggle the Dial back and forth.
4. When App prompts “Calibration Succeeded”, the remote controller calibration is completed.
8.5.2 Drone Re-paring Procedure
8.5 Drone Re-paring
8.5.1 When to perform drone re-paring
Drone re-pairing is required if you replace the drone or remote controller.
1. Turn on the remote controller, and connect the mobile device, tap Settings in the App, select “Calibration”, tap
“Re-paring the drone” to re-pair.
2. Power on the drone and long press the power button till the drone status indicators flash green, the drone is
ready to pairing.
3. Wait for about 7s, the paring succeeds when the controller beeps “Di", then you can view the live transmission
on the App interface.
To Next Page
Loading...
