33
8.2 Gimbal Calibration
8.3 Gimbal Fine-tuning
8.2.1 When to perform gimbal calibration
1. When the gimbal is not working or obviously unlevel after powering on and before take-off, please calibrate
the gimbal.
2. When the gimbal is unstable or unable to stay level in flight, please land the drone and calibrate the gimbal.
8.2.2 Calibration Procedure
8.3.1 When to perform gimbal fine-tuning
1. Tap Settings in the App, select “Gimbal Calibration”, then place the drone on a level table with the bottom
facing up.
2. Tap “Start Calibration”, then calibrate, the live transmission view will appear on the calibration interface.
3. When the progress bar is fully loaded and the App prompts "Calibration Succeeded", the calibration is
completed.
Do not move the drone significantly during the calibration process, otherwise the calibration may fail.
The gimbal fine-tuning is for manually calibrating the gimbal, and adjusting the roll and yaw offset angle of the
gimbal. You can tune the angle with reference to the status of the live transmission view on the App interface.
When the gimbal is unable to stay level or slightly tilting on level ground.
8.3.2 How to use the Gimbal Fine-Tuning
1. Tap Settings in the App, select “Gimbal Fine-Tuning”, then tune the roll and yaw angles of the gimbal with a
range of ±10°, you can tap “+/-” to adjust the gimbal angles or set the angle value directly, tap once means
“+0.1°/-0.1°”.
2. Gimbal Roll Adjustment: Tap "+" to roll to the right, and tap "-" to roll to the left.
Gimbal Yaw Adjustment: Tap "+" to yaw to the right, and tap "-" to yaw to the left.
3. Tap “Default Value” to restore the default angles ( 0° )
To Next Page
Loading...
