Tap on the left of the App interface or keep pushing the throttle control stick up for 2 seconds to exit the
descending return. The drone will switch to the regular return maintaining the current altitude.
Please pay attention to return safety, because the drone does not support obstacle avoidance and may crash
when colliding with obstacles during the return course.
For any GPS signal anomaly in communication loss return, the drone will maintain hovering at ATTI mode,
until GPS signal is strong enough and the return will resume.
7.9 Emergency Stop
See 5.3.1 Emergency stop for the detailed operation method.
Emerency stop function is designed for preventing injuring pedestrians or damaging the valuables by
propeller blades in case of drone failure. Please use it with caution, because stopping the motors mid-flight
will cause the drone to crash.
31
1. When encountering strong winds, the descending return can save power consumption and guarantee a
more successful return.
2. If the drone is disconnected from the remote controller during the descending return, it will switch to the
regular return.
This product does not have an obstacle avoidance function. Please pay attention to flight safety during the
return process.
7.8.2 Descending Return
After 10 seconds into the RTH course, if the flight altitude is greater than 150m and the flight distance greater
than 300m, the App will prompt a message for you to confirm whether to initiate the descending return. Once
confirmed, the drone will start the descending return(the drone will descend its altitude while approching the
HOME point). When its altitude descends to 120m, the drone will switch to the regular return maintaining its
current altitude till it reaches the HOME point and lands automatically.
How to Activate
How to Exit
H
Altitude/m
Flight Altitude>150m
Flight Distance>300m
Regular Return
120m
Flight Distance/m
Descending Return
>300m
To Next Page
Loading...
