Potensic ATOM - Return(RTH)

When the GPS signal is strong, tap the map in the lower left corner of the App to switch
to map, then tap on the right to enter Waypoint Flight mode, tap on the map to pin
multiple waypoints, after that tap to start Waypoint Flight.
1. Tap on the right or move a control stick (except throttle control stick) to stop and
exit the current Waypoint Flight task and the drone will hover in place.
2. Tap on the right to exit Waypoint Flight.
Description
How to Exit
How to Start
7.7.3 Waypoint Flight
When Waypoint Flight is enabled, you can pin 2 or more waypoint coordinates in App map,
and the drone will fly over the corresponding waypoints sequentially.
GO
29
You can preset 2 to 30 waypoints on the map and the figure in the icon indicates the
flight sequence.
Meanwhile, you can delete certain waypoint, save the current Waypoint Flight task, or
choose from the saved Waypoint Flight tasks.
During Waypoint Flight, you can adjust the flight altitude via the throttle control stick and the gimbal tilt via
gimbal dial.
During Waypoint Flight, the drone will exit the current flight task and hover in place if it reaches the virtual
fence.