27
Description
How to Start
How to Exit
Visual Tracking is unavailable when the drone is on the ground.
During Visual Tracking, the gimbal dial will remain unresponsive.
Once the tracked subject is lost, the drone will hover in place.
When the tracked subject is approaching the drone, it will hover in place and not move backwards.
When locking the target in Visual Tracking, the gimbal pitch angle needs to be between -75° ~ -25°.
The drone must be at least 4 m above the ground to activate Visual Tracking.
During Visual Tracking, the tracked subject should not move in a relatively high speed(recommended speed
less than 4m/s)
7.7.2 Visual Tracking
The drone tracks automatically the tracked subject to record and generates a short video which
will be saved in MicroSD card.
1. Tap in App the tap on the right to start Visual Tracking.
2. Tap or drag-select your subject, and choose the recording period(1, 3, 5min or infinite∞).
3. Tap to start Visual Tracking.
1. Tap on the right or move a control stick during recording to stop and exit Visual Tracking
and the drone will hover in place.
2. Tap on the right to exit Visual Tracking.
Use QuickShots at locations that are clear of buildings and other obstacles. Make sure there are no humans,
animals, or other obstacles on the flight path.
Before getting familiar with the flight path of QuickShots, please try a smaller flight distance first.
Be ready to take over control of the drone by moving any control stick at any time in emergency and the
drone will exit QuickShots and hover in place.
Pay attention to objects around the drone and use the remote controller to avoid collision with the drone or
when the drone is being blocked.
DO NOT use QuickShots in places that are close to buildings or where the GPS signal is weak. Otherwise, the
flight path will be unstable.
Make sure to follow local privacy laws and regulations when using QuickShots.
QuickShots is not available in the following situations:
1. The drone is on the ground.
2. GPS signal is weak.
3. MicroSD card is not inserted or no storage available.
4. The battery level is low.
5. The current altitude of the drone is insufficient.
6. The drone reaches the virtual fence.
7. The gimbal is horizontal or tilted upwards.
DO NOT use QuickShots in any of the following situations where the Downward Vision System may not work
properly:
1. When the subject is blocked or outside the line of sight for an extended period.
2. When the subject is more than 50 m away from the drone.
3. When the subject is similar in color or pattern with the surroundings.
4. When the subject is in the air.
5. When the subject is moving fast.
6. When the ambient lighting is extremely low or high.
QuickShots does not support video recording in 1080P@60/50fps.
After the subject is locked in QuickShots, the gimbal pitch angle can't be adjusted.
To Next Page
Loading...
