Operation
120-393 632.4 04.08 Fh
PARAMOUNT two 30 - 115 kW 35
By pressing the information button, further information can be
called up (see servicing code table).
The maintenance message has not been activated by the setting in
the factory.
Chimney-sweep function The chimney-sweep function is activated or deactivated by the
chimney-sweep button . The activated special function is dis-
played by the symbol n the display.
Restore standard values
The standard values will be restored as described below:
– Select level engineer and prog.-nr. 31
– Change to Yes and wait until value is switching back to No
– Leave menu by pressing ESC
You can find more information for adjusting parameters in the sec-
tion section 8. „Programming”.
To Next Page
Loading...
