Install the equipment, both the power station and the recharging posts, on a solid, level surface
in a location where there is no risk of explosion, flooding, or impact damage. Follow the
recommendations on how to build the foundation of this manual. Otherwise, there is a risk of
malfunction and even permanent damage.
Never clean the surfaces or the inside of the equipment with abrasive liquids, solvents or cleaning
products that could damage it. Water should not be applied under excessive pressure.
Disconnect the input power in case the equipment gets damaged.
Otherwise, it could result in a secondary accident or a fire.
Do not allow lint, paper, wood chips, dust, metallic chips, or other foreign matter into
the equipment. Otherwise, a fire or an accident could occur.
After the input power is applied or removed, the equipment will remain hot for a few
minutes. Touching internal hot parts could result in skin burns
IMPORTANT RECOMMENDATIONS FOR CHARGING ELECTRIC VEHICLES:
Follow at all times the charging process described by the electric vehicle manufacturer.
This device should be monitored when used near children.
Do not handle the vehicle or equipment during the loading process (washing of the vehicle,
intervention in the vehicle engine compartment, handling of the loading post, etc.).
Do not modify or interfere with the electrical installation while charging the vehicle.
Failure to do so could result in electric shock.
Do not charge the vehicle in the event of water, signs of corrosion or foreign matter on the charger
cable connector or vehicle charging socket. Otherwise, there is a risk of fire and electric shock.
Do not attempt to touch the terminals of the charging station connector cable or the vehicle
charger socket, nor insert objects into them. Failure to do so could result in electric shock.
Do not attempt to disassemble, repair, alter or modify the charging connector or any part of the
charger. The connector is not a user-serviceable device. Contact Power Electronics.
Always be careful with the charger's cable and connector: treat it carefully, do not crush it,
immerse it in water, pull it out, or hit it, etc.
Follow the directions given by the vehicle manufacturer regarding the suitability of charging the
vehicle when you or the vehicle are exposed to intense rain, heavy electrical storm, or other severe
weather.
To Next Page
Loading...
Need help?
General
