Reception
The equipment is delivered perfectly packed and checked. Upon receipt, inspect the equipment. In the
event of damage to the equipment, notify the logistics agent and Power Electronics 902 40 20 70,
(International +34 96 136 65 57), or your nearest agent within 24 hours of receipt. Verify that the goods
received correspond to the delivery note, models and serial numbers.
Storage
Whenever possible, the equipment should be unloaded at its place of installation and operation.
If it is necessary to store the equipment, it must be kept in its original packaging and the following rules
must be followed to keep it in proper condition:
• Store the equipment in a place protected against harmful elements such as animal entries, excess
moisture (inside and outside the equipment), thermal radiation, direct solar radiation, contact with
chemicals, corrosive gases, etc.
• Store the equipment on a flat, level surface. Never rest the equipment on wooden beams
• Store equipment away from passageways where it may be damaged
• Keep the covers on during storage.
• Keep the equipment packed until the time of installation.
• The temperature in the storage location must be between -40°C y +60°C and the relative humidity at
<95% without condensation.
Standard storage is defined as the expected time period from the time the equipment arrives at its
location until its commissioning occurs. It is assumed that this period is less than 6 months. This
period is variable according to the weather conditions of the site.
Customer is responsible of deciding if the posts are installed within the standard period or
otherwise, the installation date is to be defined. In this case, customer must take the appropriate
measures.
To Next Page
Loading...
Need help?
General
