Advanced charge functionality
Smart Fleet Management
This functionality has been designed to minimize the initial investment and operation costs.
It is able to balance the power based on the number of charging posts in use. Therefore, the total power
required to supply the total energy gets substantially reduced, representing a cost reduction in the
electrical facility infrastructure and a cost saving due to a minor power contracted. Besides, the
hardware and the back-office communication are optimized.
Smart power balance technology (optional)
With the smart power balance functionality, NB 120 is able to dynamically allocate power modules
depending on the power demand of each vehicle.
This functionality optimizes the use of the total power of the charger and therefore the investment.
Simultaneous charging
The NB 120 is designed for maximum revenue from a single charger. Allows working with voltage
ranges between 150 Vdc and 1000 Vdc and can work between 300 Vdc and 1000 Vdc at maximum
power.
IEC standard
Each charger can install up to two connectors per post, allowing the simultaneous charging of two
vehicles in DC. Optionally, an AC socket can be included, for an AC charge. The charger is compatible
with the most extended connectors for DC charging (CCS, CHAdeMO) and AC.
US standard
Each charger can install up to two connectors per post, allowing the simultaneous charging of two
vehicles in DC. The charger is compatible with the most extended connectors for DC charging (CCS,
CHAdeMO).
Open door detection
Door contact switches are used in order to recognize if the front access door of the power cabinet is
open. If it is detected that the door is open, ongoing charging sessions will be immediately stopped.
To Next Page
Loading...
Need help?
General
