2
1. INTRODUCTION
1.1 General Description
The Solar Inverter, a powerful all-in-one solution, delivers unsurpassed clean
true sine wave output power and combines this with a selectable multistage
battery charging current. Applicable for any kind of loads such as air
conditioner, home appliances, consumer electronic and office equipments.
This series features a durable&continuous 24 operation.
The built-in 5-stage intelligent charger automatically charges any type of
batteries without the risk of overcharge. The compact&modular design
makes utility interactive installations easier and more cost effective. It is a
high quality product that offers the best price/performance ratio in the
industry.
1.2 Key features
1. Multiple microprocessor design base.
2. Compatible with both linear&non-linear load.
3. Stronger charger to support batteries of 500AH up.
4. 24 hours operation on the inverter.
5. DC start and automatic self-diagnostic function.
6. THD less than 3%.
7. High efficiency design to save electricity.
8. Low heat dissipation in long time operation
9. Design to operate under harsh environment
10 3U 19” Rack Mount or WALL Mounted design
1.3 Important Notices
1. Read instructions carefully before operating the Solar Inverter.
2. Solar Inverter power connect instruction should be followed.
3. Please don‘t open the case to prevent danger.
5. Retain the load within the rating of Solar Inverter to prevent faults.
6. Keep the Solar Inverter clean and dry.
3
2. SAFTY INSTRUCTION
2.1 Transporting
1. Disconnect all power cables if necessary.
2. Be careful not to damage the Solar Inverter while transporting.
3. Don‘t move the Solar Inverter upside down.
4. Please transport the Solar Inverter system only in the original packaging (to
protect against shock and impact).
2.2 Positioning
1. Do not put the Solar Inverter on rugged or declined surface.
2. Do not install the Solar Inverter system near water or in damp
environments.
3. Do not install the Solar Inverter system where it would be exposed to direct
sunlight or near heat.
4. Do not block off ventilation openings in the Solar Inverter system’s housing
and don’t leave objects on the top of the Solar Inverter.
5. Keep the Solar Inverter far away from heat emitting sources.
6. Do not expose it to corrosive gas.
7. Ambient temperature : 0℃ - 40℃
2.3 Installation
1. Connect the Solar Inverter system only to an earthed shockproof socket
outlet.
2. Place cables in such a way that no one can step on or trip over them.
To Next Page
Loading...
