Power Plus HD800S - TROUBLE SHOOTING

17
TROUBLE SHOOTING
Problem
Possible Cause
What To Do
The display on the front
panel does not light up
Main cable is not connected
Check that the main cable is
plugged into power socket
No sound or picture,
but the front panel red
light is ON
The unit is in standby mode
Press the standby button
No sound or picture
The satellite dish is not
pointing at the satellite
Adjust the dish.
Check the Signal Lever in the Antenna
Setup menu
No signal or weak signal
Check the cable connections, LNB and
other equipment connected between the
LNB and the receiver, and/or adjust the
dish
Bad picture/Blocking error
The satellite dish is not
pointing at the satellite
Adjust the dish
Signal is too strong
Connect a signal attenuator to the LNB
input
Satellite dish is too small
Change to an LNB with lower noise a
factor
The LNB is faulty
Change the LNB
No picture appears on the
TV screen
TV is not in AV/EXT mode
Check the UHF channel fixed in your
system and tune the UHF channel
properly
The RCU is not working
Battery exhausted
Change the battery
RCU is incorrectly aimed
Aim the RCU at the unit, or check that
nothing blocks the front panel