6
Menu Operations
FIRST STEPS
1. Turn on STB
Turn on the unit. If the STB is opened for the 1st time, it maybe will show “Program not exist” or“No signal” on
menu. If the STB open after used, STB will play the same channel as last time before turning off.
2. STANDBY
1. Press [STANDBY] key, you can enter the Standby state;
2. In Standby state, press [STANDBY] key again, you can call back the unit and go on playing the channel;
3. User can also switch off the STB to end the Standby state by press the [Device’s Main Power];
3. Channel Up / Channel Down
In full screen, press[▲ ▼] to change channel. You can change channels in channel list too.
4. Volume Up/Volume Down
In full screen, press [ ] to adjust volume.
5. OK
1. In full screen, press [ok] key, you can enter “Channel list”.
2. Press [▲ ▼] key to move highlight and press [ok] key to play the highlighted channel.
3. Press [ ] key to select channels from a particular satellite.
6. MEDIA
Press [MEDIA] key to enter “media player” in full screen. There you can play MP3/video/book/picture.
7. FAST SCAN
Press [USB] key to search satellite by auto scan.
8. INFO
Press [INFO] key once, you can see basic information of the channel you watch.
Press [INFO] key twice, you will enter the signal indicator window. There you can check the strength/quality/video
format / audio format etc.
To Next Page
Loading...