13
4. Utility
When you press [MENU] key to enter menu, there will display the picture like below:
System Information
The screen shows some information about SW and HW. Press [EXIT] key to draw back from this menu.
Factory Reset
When you press [ok] key in the “Factory Reset” item，there will pop up a small window to inquiry you to input
default password “0000”. And if you input right, the system will reset to default and erase all the channels and
other parameters you added. Please be careful to use this function.
Software Upgrade
When you enter to “Firmware Upgrade” menu, you will see a screen as below:
1. USB Upgrade：Choose the right path to select SW named like “*.bin”, then move the highlight to “Start” and
press [ok] key to begin upgrading.
2. STB to STB: Firstly，please link your STB’s RS23 to the other STB whose sw you want to use and you can
upgrade by pressing [ok] key.
Dump: When you want to use SW in your STB, you can choose “Dump” mode. Select the USB device and press
[ok] key to start.
To Next Page
Loading...